Deployment Guide

26 VxRail Networking Guide with Dell EMC S4148-ON Switches | version 1.0
description "40Gb Uplink to Customer 2"
channel-group 2 mode active
no shutdown
no switchport
interface ethernet1/1/26
description "40Gb Uplink to Customer 2"
channel-group 2 mode active
no shutdown
no switchport
description "40Gb Uplink to Customer 2"
channel-group 2 mode active
no shutdown
no switchport
interface ethernet1/1/26
description "40Gb Uplink to Customer 2"
channel-group 2 mode active
no shutdown
no switchport
2. Save the configuration using the following command from the enable prompt:
Switch-1# Write Memory
4.4.3 Network facing uplink configuration - 10GbE
Configure the network-facing upstream ports as LAGs in the ISLs port configuration section. The examples
show both 10GbE and 100GbE interfaces. Section 4.4.2 also covers the configuration steps for 40GbE
connections. LAGs can connect to multiple upstream switches if they support multi-chassis LAG features
such as vPC, or VLT.
The example shows 10GbE port configurations for reference information.
1. Configure the network facing uplinks on Switch 1 using the following commands: (10GbE recommended
port values shown)
10GbE Network facing uplink configuration
Switch-1 (S4148-ON)
Switch-2 (S4148-ON)
interface ethernet 1/1/23
description "10Gb Uplink to Customer 1"
channel-group 1 mode active
no ip address
no shutdown
interface ethernet 1/1/24
description "10Gb Uplink to Customer 1"
channel-group 1 mode active
no ip address
no shutdown
interface port-channel 1
description "10Gb LAG to customer 1"
no ip address
switchport mode trunk
switchport trunk allowed vlan 110,130
no shutdown
interface ethernet 1/1/23
description "10Gb Uplink to Customer 1"
channel-group 1 mode active
no ip address
no shutdown
interface ethernet 1/1/24
description "10Gb Uplink to Customer 1"
channel-group 1 mode active
no ip address
no shutdown
interface port-channel 1
description "10Gb LAG to customer 1"
no ip address
switchport mode trunk
switchport trunk allowed vlan 110,130
no shutdown