Administrator Guide
Table Of Contents
- Dell EMC BIOS User guide
- About this guide
- New in this release
- BIOS
- BIOS setup
- How to boot into BIOS settings after upgrade
- How to retrieve a VEP4600 product service tag
- How to change the default BIOS password
- Password reset
- Hardware flow control
- Super IO configuration
- Boot order
- Server management
- Option ROM dispatch policy
- SR-IOV support
- USB 3.0
- PXE and HTTP boot support
- Network interface configuration
- Advanced power management
- Trusted computing
- Embedded DIAGS
- Dell EMC support
Option ROM dispatch policy
Option read-only memory (ROMs) contain firmware that the BIOS executes. The values listed on this screen and in the
Compatibility Support Module screen use default values when the Restore if Failure setting is true and the BIOS fails to
boot up.
NOTE: Changing the option ROM settings may effect the BIOS boot up. Dell EMC recommends keeping the default value
of Restore if Failure equals true.
Access the option ROM dispatch policy screen from the BIOS setup screen, select the Advanced tab, then select Option
ROM Dispatch Policy.
Figure 14. Option ROM dispatch policy
SR-IOV support
If VEP4600 uses Virtualization Technologies, you must enable the single root I/O virtualization (SR-IOV) SR-IOV support
option.
Access this option from the BIOS setup screen, select the Advanced tab, then select SR-IOV Support.
NOTE: This SR-IOV feature is enabled in the BIOS factory default configuration.
Configure SR-IOV in X710 rNDC card.
●
Check Network UEFI Configuration
24
BIOS