Users Guide
Table Of Contents
- Dell EMC VEP4600 BMC User Guide
- About this guide
- New in this release
- Hardware and software support
- BMC web GUI
- Configuration methods
- Current released firmware
- Remote power cycle system
- Access system health sensors
- Access FRU data
- ipmiutil package
- Dell EMC support
Table 4. Firewall set parameters (continued)
Type specific param # Parameter data
9—hour
10—minute
Date 11-16—stop time
[11:12]—Year
LS-byte first if little endian system. Two-
byte data required to form year.
13—month
14—date
15—hour
16—minute
Add IPv4 range of addresses with
timeout rule
12
Data 1:8—IP address
[1:4]—Starting IP address blocked or
unblocked based on the state.
[5:8]—Ending IP address till IPs are
blocked or unblocked based on the state.
Date 9:14—Start time
[9:10]—Year
LS-byte first if little endian system. Two-
byte data required to form year.
11—month
12—date
13—hour
14—minute
Date 15-20—Stop time
[15:16]—Year
LS-byte first if little endian system. Two-
byte data required to form year.
Add the IPv4 port number with timeout
rule
13
Data 1—Protocol TCP and UDP
0 = TCP
1 = UDP
2 = both TCP and UDP
Data 2:3—port number
[2:3]—Port number from the ports
blocked or unblocked based on the state.
Date 4:9—Start time
[4:5]—Year
LS-byte first if little endian system. Two-
byte data required to form year.
6—month
7—date
8—hour
9—minute
Date 10-15—stop time
[10:11]—Year
LS-byte first if little endian system. Two-
byte data required to form year.
12—month
13—date
14—hour
15—minute
Add the IPv4 port range with timeout
rule
14
Data 1:—Protocol TCP and UPD
0 = TCP
1 = UDP
2 = both TCP and UDP
Data 2:5—port number
[2:3]—Port number from the ports
Configuration methods 59