Users Guide
Table Of Contents
- Dell EMC VEP4600 BMC User Guide
- About this guide
- New in this release
- Hardware and software support
- BMC web GUI
- Configuration methods
- Current released firmware
- Remote power cycle system
- Access system health sensors
- Access FRU data
- ipmiutil package
- Dell EMC support
Table 4. Firewall set parameters (continued)
Type specific param # Parameter data
blocked or unblocked based on the state.
[4:5]—Port number till the ports blocked
or unblocked based on the state.
Date 6:11Start time
[6:7]—Year
LS-byte first if little endian system. Two-
byte data required to form year.
8—month
9—date
10—hour
11—minute
Date 12-17—stop time
[12:13]—Year
LS-byte first if little endian system. Two-
byte data required to form year.
14—month
15—date
16—hour
17—minute
Remove the IPv4 address with timeout
rule
15
Data 1:4—IP address
MS-byte first. The IPv4 address type
blocked or unblocked based on the state.
Date 5:10—Start time
[5:6]—Year
LS-byte first if little endian system. Two-
byte data required to form year.
7—month
8—date
9—hour
10—minute
Date 11-16—stop time
[11:12]—Year
LS-byte first if little endian system. Two-
byte data required to form year.
13—month
14—date
15—hour
16—minute
Remove the range IPv4 address with
timeout rule
16
Data 1:8—IP address
[1:4]—Starting IP address blocked or
unblocked based on the state.
[5:8]—Ending IP address till IPs are
blocked or unblocked based on the state.
Date 9:14—Start time
[9:10]—Year
LS-byte first if little endian system. Two-
byte data required to form year.
11—month
12—date
13—hour
14—minute
Date 15-20—Stop time
[15:16]—Year
LS-byte first if little endian system. Two-
byte data required to form year.
17—month
18—date
60 Configuration methods