Users Guide
Table Of Contents
- Dell EMC VEP4600 BMC User Guide
- About this guide
- New in this release
- Hardware and software support
- BMC web GUI
- Configuration methods
- Current released firmware
- Remote power cycle system
- Access system health sensors
- Access FRU data
- ipmiutil package
- Dell EMC support
Table 4. Firewall set parameters (continued)
Type specific param # Parameter data
19—hour
20—minute
Remove the IPv4 port number with
timeout rule
17
Data 1—Protocol TCP and UDP
0 = TCP
1 = UDP
2 = both TCP and UDP
Data 2:3—port number
[2:3]—Port number from the ports
blocked or unblocked based on the state.
Date 4:9—Start time
[4:5]—Year
LS-byte first if little endian system. Two-
byte data required to form year.
6—month
7—date
8—hour
9—minute
Date 10-15—stop time
[10:11]—Year
LS-byte first if little endian system. Two-
byte data required to form year.
12—month
13—date
14—hour
15—minute
Remove the IPv4 port number range
with timeout rule
18
Data 1:—Protocol TCP and UPD
0 = TCP
1 = UDP
2 = both TCP and UDP
Data 2:5—port number
[2:3]—Port number from the ports
blocked or unblocked based on the state.
[4:5]—Port number till the ports blocked
or unblocked based on the state.
Date 6:11Start time
[6:7]—Year
LS-byte first if little endian system. Two-
byte data required to form year.
8—month
9—date
10—hour
11—minute
Date 12-17—stop time
[12:13]—Year
LS-byte first if little endian system. Two-
byte data required to form year.
14—month
15—date
16—hour
17—minute
Drop all IPv4 or IPv6 with timeout rule
19
Add iptables rules to block IPv4 and IPv6
traffic to the BMC. The state selector is
not used.
Data1: Protocol
Bit 7:2—Reserved
Bit 1—IPv6
Configuration methods 61