Users Guide
Table Of Contents
- Dell EMC VEP4600 BMC User Guide
- About this guide
- New in this release
- Hardware and software support
- BMC web GUI
- Configuration methods
- Current released firmware
- Remote power cycle system
- Access system health sensors
- Access FRU data
- ipmiutil package
- Dell EMC support
Table 4. Firewall set parameters (continued)
Type specific param # Parameter data
26—date 27—hour
28—minute
Add IPv6 address range with timeout
rule
22
Data 1:16—IPv6 address range
[1:16]—Port number from the ports
blocked or unblocked based on the state.
[17:32]—Port number till the ports
blocked or unblocked based on the state.
Date 33:38—Start time
[33:34]—Year
LS-byte first if little endian system. Two-
byte data required to form year.
35—month
36—date
37—hour
38—minute
Date 39:44—stop time
[39:40]—Year
LS-byte first if little endian system. Two-
byte data required to form year.
41—month
42—date
43—hour
44—minute
Remove the IPv6 address with timeout
rule
23
Data 1:16—IPv6 address
MS-byte first. The IPv4 address type
blocked or unblocked based on the state.
Date 17:22—Start time
[17:18]—Year
LS-byte first if little endian system. Two-
byte data required to form year.
19—month
20—date
21—hour
22—minute
Date 23-28—stop time
[23:24]—Year
LS-byte first if little endian system. Two-
byte data required to form year.
25—month
26—date
27—hour
28—minute
Remove the Ipv6 address range with
timeout rule
24
Data 1:16—IPv6 address range
[1:16]—Port number from the ports
blocked or unblocked based on the state.
[17:32]—Port number till the ports
blocked or unblocked based on the state.
Date 33:38—Start time
[33:34]—Year
LS-byte first if little endian system. Two-
byte data required to form year.
35—month
36—date
37—hour
38—minute
Date 39:44—stop time
Configuration methods 63