Users Guide

Table Of Contents

NOTE: "x" indicates current version of file.

root@dellemc-diag-os:~# updatetool -D CPLD --index=1 -U -e xxxx_CPLD_Vxx.vme

Disable device protect

Disable CPLD protect operation success, wait HW reset

Write image to CPLD

INFO: Yafu INI Configuration File not found... Default options will not be applied...

Creating IPMI session via USB...Done

-------------------------------------------------

YAFUFlash - Firmware Upgrade Utility (Version 5.0.0)

-------------------------------------------------

Beginning CPLD Update...

Uploading Image : 100%... done

Flashing Firmware Image : 100%... done

Verifying Firmware Image : 100%... done

write CPLD image success

Enable device protect

Update CPLD image success

2. When all of the firmware updating completes you must either unplug and replug power cables, or power-down and

power-up using the remote power cycle command of the system.

The new CPLD updates will take effect only after the system is power-cycled.

Remote firmware update

Update your BMC, BIOS, and CPLD firmware with the following commands.

NOTE: DIAG OS version 6 is the minimum configuration to install VEP4600 Expansion Cards.

Boot into BIOS settings

Steps

1. Press the delete button after the POST Lower DRAM Memory test appears on the screen. Continue pressing the

delete button to progress to the BIOS setup and configuration screen.

NOTE:

If the BIOS setup and configuration screen window passes, power-off, and power-on the unit. Either

turn off the processor using the software console or hold the processor power on/off button down for five seconds.

2. Boot into BIOS settings.

Current released firmware