Users Guide
Table Of Contents
- Dell EMC VEP4600 BMC User Guide
- About this guide
- New in this release
- Hardware and software support
- BMC web GUI
- Configuration methods
- Current released firmware
- Remote power cycle system
- Access system health sensors
- Access FRU data
- ipmiutil package
- Dell EMC support
5. Select Save & Exit Setup and choose Yes.
Network interface settings
Steps
1. After booting up, go to BMC console to check the network interface settings.
ifconfig
eth0 Link encap:Ethernet HWaddr 54:BF:64:A9:E7:C9
inet addr:xxx.xx.xxx.xx Bcast:xxx.xx.xxx.xxx Mask:255.255.255.0
inet6 addr: fe80::56bf:64ff:fea9:e7c9/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:2495 errors:1 dropped:837 overruns:0 frame:1
TX packets:442 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
Current released firmware
79