Install Guide
Table Of Contents
- Dell EMC VEP4600 Installation Guide
- About this guide
- VEP4600 platform
- Site preparations
- VEP4600 installation
- Power supplies
- Fans
- Management ports
- Specifications
- Chassis physical design
- IEEE standards
- Safety standards and compliance agency certifications
- Product recycling and disposal
- Agency compliance
- USA Federal Communications Commission statement
- Industry Canada Statement
- Brazil – Aviso da Anatel
- European Union EMC directive conformance statement
- Japan VCCI compliance for class A equipment
- Korean certification of compliance
- Mexico certification of compliance
- Taiwanese certification of compliance
- Thailand certification of compliance
- Singapore certification of compliance
- Dell EMC support
● Short push:
○ Sends ACPI power event to the Operating System (OS.)
NOTE: Response depends on configuration of how the OS is booted-up when it receives a ACPI power event. The
response may ignore the button push or shutdown the system.
● Long push:
○ Sends ACPI power event to the OS and immediately puts the CPU to sleep. When CPU is in sleep state, a short push
brings the CPU out of sleep and reboots the system.
CAUTION: Always turn off the processor correctly. Hold the ACPI on/off button down for five seconds to
boot-up after a correct processor shutdown.
NOTE: Before you unplug the platform power cable, either turn off the processor using the software console or hold the
ACPI on/off button down for five seconds.
Storing components
If you do not install your VEP4600 and components immediately, properly store the platform and all optional components using
these guidelines:
● Storage location temperature must remain constant. The storage range is from -40°C to 70°C (-40°F to 158°F).
● Store on a dry surface or floor, away from direct sunlight, heat, and air conditioning ducts.
● Store in a dust-free environment.
NOTE: ESD damage can occur when components are mishandled. Always wear an ESD-preventive wrist or heel ground
strap when handling the VEP4600 and accessories. After you remove the original packaging, place the VEP4600 and
components on an anti-static surface.
Site preparations 15