Setup Guide

Whip antennas on the VEP4600 WIFI card

All antennas should be articulated to upright position for optimal performance. There should not be large metal objects within a three foot

radius of the antenna.

1. WIFI 1

2. BT/BLE

3. WIFI 2

VEP4600 WIFI Card whip antennas

Agency compliance

The VEP4600 is designed to comply with the following safety and agency requirements:

USA Federal Communications Commission statement

CAUTION:

The use of external signal amplifiers in-line with the transceiver antennas is strictly prohibited.

CAUTION: Use only the antenna(s) which have been approved by the applicant. Non-approved antenna(s) may produce

unwanted spurious or excessive RF transmitting power which may lead to a violation of FCC/IC limits and is prohibited.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1) This device may not cause harmful interference, and (2) this device must accept any interference received, including

interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the

FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment

generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If

this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one of the following measures.

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

FCC Caution:

Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate

this equipment.

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

Specifications