Users Guide
Firmware upgrades
Manual or automatic BMC, BIOS, and CPLD rmware upgrades is required before VEP4600 Expansion Card installation.
NOTE: Minimum rmware requirements
Table 4. Required rmware minimum release requirements.
Device Firmware Minimum rmware release required
when installing an rNDC Card
Minimum rmware release required
when installing the WIFI or LTE Card
VEP4600 BMC v1.22 v1.23
BIOS v3.41.0.9-10 3.41.0.9-13
CPLD V0C V0C
DIAGS OS 3.41.3.81-4 3.41.3.81-5 (rNDC, WIFI/LTE)
DIAGS Tools 3.41.4.81-15 3.41.4.81-16 (rNDC (WIFI/LTE)
Expansion Card - rNDC
Carrier
CPLD v02 n/a
Expansion Card - Wi or
LTE Card
CPLD n/a R01
Topics:
• USB based rmware update
• Remote rmware update
USB based rmware update
Update your BMC, BIOS, and CPLD rmware with the following commands.
NOTE
: DIAG OS version 6 is the minimum conguration to install VEP4600 Expansion Cards.
Power on VEP4600
Plug in a power cord to the back of VEP4600 platform. The platform starts to power up immediately.
Create a serial console connection
To establish a console connection use a universal serial bus (USB)-to-RS-232 connection from a USB port to a VEP4600 console port.
NOTE
: Use a 115200 baud rate.
5
76 Firmware upgrades