Administrator Guide
Table Of Contents
- Dell EMC BIOS User guide
- About this guide
- New in this release
- BIOS
- BIOS setup
- How to boot into BIOS settings after upgrade
- How to retrieve a VEP4600 product service tag
- How to change the default BIOS password
- Password reset
- Hardware flow control
- Super IO configuration
- Boot order
- Server management
- Option ROM dispatch policy
- SR-IOV support
- USB 3.0
- PXE and HTTP boot support
- Network interface configuration
- Advanced power management
- Trusted computing
- Embedded DIAGS
- Dell EMC support
Figure 7. Hardware RTS/CTS
3. Press F4 to save and exit BIOS.
Super IO configuration
The VEP4600 only has the serial port on the Super I/O (SIO) chip. The chip settings are preconfigured and normally do not need
changing.
However, you can use the BIOS to change the Super I/O chip settings, such as the I/O Base, interrupt request line (IRQ), and
direct memory access (DMA) channel. To access these settings, from the BIOS setup screen, select the Advanced tab, then
select SIO Configuration.
20
BIOS