Reference Guide

ONIE: Executing installer: /diag-installer-x86_64-dellemc_vep4600_d21xyt-r0-x.xx.x.xx-
x-2018-04-24.bin
Ignoring Verifying image checksum ... OK.
cur_dir / archive_path /var/tmp/installer tmp_dir /tmp/tmp.XeWxoj
Preparing image archive ...sed -e '1,/^exit_marker$/d' /var/tmp/installer | tar xf -
OK.
Diag-OS Installer: platform: x86_64-dellemc_vep4600_d21xyt-r0
EDA-DIAG Partiton not found.
Diag OS Installer Mode : INSTALL
Deleting partition at /dev/sdc1...
The operation has completed successfully.
Deleting partition at /dev/sdc2...
The operation has completed successfully.
Deleting partition at /dev/sdc3...
The operation has completed successfully.
Deleting partition at /dev/sdc4...
Partition number 4 out of range!
Error 0 deleting partition!
Error encountered; not saving changes.
Error: Unable to delete partition 4 on /dev/sdc
Removing /tmp/tmp.XeWxoj
Failure: Unable to install image: /diag-installer-x86_64-dellemc_vep4600_d21xyt-r0-
x.xx.x.xx-x-2018-04-24.bin
+ echo This should be not reachable unless something wrong is there!!!!!
This should be not reachable unless something wrong is there!!!!!
Starting: dropbear ssh daemon... done.
Starting: telnetd... done.
discover: Rescue mode detected. Installer disabled.
Please press Enter to activate this console.
To check the install status inspect /var/log/onie.log.
Try this: tail -f /var/log/onie.log
To resolve this issue, delete the partition completely and restart the DIAG OS installation.
Configure BIOS and boot into DIAG OS
After the DIAG OS installation completes, remove the USB flash driver used for installation. Configure the BIOS then boot into
the DIAG OS.
1. Boot into the BIOS setting.
2. Configure Boot Option #1 from the Boot Configuration screen.
Figure 11. Boot configuration screen
3. Press the F4 key to save the changes and exit the utility.
4. Confirm saving the configuration using the left and right arrow keys, and exit from the utility. Select Yes and press Enter.
DIAG OS installation
35