Users Guide

Network settings
Network sections:
● Network IP settings
● Network link configuration
● DNS configuration
Setup each Log settings section using the options supplied.
Network settings screen
Network IP settings
Enable LAN
Check this option to enable LAN support for the selected interface.
LAN interface
Select the LAN interface to be configured.
MAC address
This field displays the MAC address of the selected interface (read only).
Enable IPv4
Check this option to enable IPv4 support for the selected interface.
Enable IPv4 DHCP
Check this option to enable IPv4 DHCP support to dynamically configure IPv4 address using Dynamic Host Configuration
Protocol (DHCP).
IPv4 Address
If DHCP is disabled, specify a static Subnet Mask to be configured for the selected interface.
● IP Address consists of four sets of numbers separated by dots as in 'xxx.xxx.xxx.xxx'.
● Each set ranges from 0 to 255.
● First Number must not be 0.
IPv4 Subnet
If DHCP is disabled, specify a static Default Gateway to be configured for the selected interface.
● IP Address consists of four sets of numbers separated by dots as in 'xxx.xxx.xxx.xxx'.
● Each set ranges from 0 to 255.
● First Number must not be 0.
IPv4 Gateway
If DHCP is disabled, specify a static Default Gateway to be configured for the selected interface.
● IP Address consists of four sets of numbers separated by dots as in 'xxx.xxx.xxx.xxx'.
● Each set ranges from 0 to 255.
● First Number must not be 0.
Enable IPv6
16
BMC web GUI