Users Guide
Table Of Contents
- Dell EMC VEP4600 BMC User Guide
- About this guide
- New in this release
- Hardware and software support
- BMC web GUI
- Configuration methods
- Current released firmware
- Remote power cycle system
- Access system health sensors
- Access FRU data
- ipmiutil package
- Dell EMC support
Existing IP Rules
This page displays list of Existing IP firewall rules.
Click X icon to delete an item from the list.
To view the page, user must at least be an Operator. To add or delete a firewall, user must be an Administrator.
Add IP Rule
IP Single (or) Range Start
This field is used to configured the IP address or Range of IP addresses. An IP address will support IPv4 address format only:
● IPv4 Address made of 4 numbers separated bydots as in xxx.xxx.xxx.xxx.
● Each number ranges from 0 to 255.
● First number must not be 0.
IP Range End
This field is used to configured the IP address or Range of IP addresses. An IP address will support IPv4 address format only:
● IPv4 Address made of 4 numbers separated bydots as in xxx.xxx.xxx.xxx.
● Each number ranges from 0 to 255.
● First number must not be 0.
Enable Timeout
This option used to enable or disable firewall rules with timeout.
Start Date
The respective firewall rule effect will start from this date.
Start Time
The respective firewall rule effect will start from this time.
End Date
The respective firewall rule effect will end from this date.
End Time
The respective firewall rule effect will end from this time.
BMC web GUI
35