Install Guide

3. Enter 1 Automatically update all firmware components.
updating ALL images
updating BMC image
****************************
* BMC version = x.x *
* Back-up Version = x.x *
****************************
Already have x.x programmed
updating BIOS image
******************************
* BIOS version = 3.41.0.x-xx *
******************************
updating primary image only..
BIOS image is ./VEP4600-BIOS-3.41.0.x-xx.BIN
01
INFO: Yafu INI Configuration File not found... Default options will not be applied...
Creating IPMI session via USB...Done
-------------------------------------------------
YAFUFlash - Firmware Upgrade Utility (Version 4.11x.x)
-------------------------------------------------
(C)Copyright 2016, American Megatrends Inc.
Beginning BIOS Update...
Uploading Image : 100%... done
Flashing Firmware Image : 100%... done
Verifying Firmware Image : 100%... done
Done with updating image
Will continue to update rest of components
Power cycle cpu to boot new BIOS after update is complete
updating CPLD image
Already have XxXX programmed
updating MC1_CARD CPLD image
Already have 0x2 programmed
WARNING: To avoid damage to your device, do not stop the update or reboot or power
off the system during t update.
Intel(R) Ethernet NVM Update Tool
NVMUpdate version 1.32.20.18
Copyright (C) 2013 - 2018 Intel Corporation.
done updating
Power cycle chassis for updates to take effect
Package version: x.x
Packaged images:
BMC image: x.x
BIOS image: 3.41.0.x-xx
CPLD image: XxXX
Note:If BMC version is less than 1.23 CPLD versions will not be shown correctly
1. Automatically update all firmware components
2. BMC image[Primary version:x.x, backup version:1.23]
3. BIOS image[Booted version: 3.41.0.x-xx]
4. CPLD image[CPLD version: XxXX]
5. rNDC left CPLD image[CPLD version: 0x2]
6. rNDC right CPLD image[CPLD version: 0x2]
7. Intel rNDC firmware update[ left Type: X710, (18.8.9)]
[ right Type: X710, (18.8.9)]
q. Exit
Enter your choice:q
14
Upgrade firmware through DiagOS