Install Guide

VEP4600 installation

To install the VEP4600, complete the installation procedures in the order presented in this section.

Always handle the platform and components with care. Avoid dropping the platform or its field replaceable units (FRUs).

NOTE: ESD damage can occur if components are mishandled. Always wear an ESD-preventive wrist or heel ground strap

when handling the VEP4600 and components. As with all electrical devices of this type, take all the necessary safety

precautions to prevent injury when installing this platform.

Topics:

• Unpack

• VEP Expansion Card installation

• Ground lug

• Rack or cabinet hardware installation

• Two-post installation

• Alternative mounting positions

• Four-post installation

• Optics installation

• Platform power-up

Unpack

Unpack the platform carefully.

NOTE: Before unpacking the platform, inspect the container and immediately report any evidence of damage.

When unpacking the platform, make sure that the following items are included:

• One VEP4600

• One RJ-45 to DB-9 female cable

• Two-post rail kit; no tools required

• One or two country- or region-specific AC power cords, depending on the configuration

• VEP4600 Setup Guide

• Safety and Regulatory Information

• Warranty and Support Information

1. Place the container on a clean, flat surface and cut all straps securing the container.

2. Open the container or remove the container top.

3. Carefully remove the platform from the container and place it on a secure and clean surface.

4. Remove all packing material.

5. Inspect the product and accessories for damage.

VEP Expansion Card installation

NOTE:

Customers are not to attempt installing Virtual Edge Platform (VEP) 4600 expansion cards. A Dell EMC Certified

technician must perform this installation.

CAUTION: The mezzanine cards are intended for professional installation only.

CAUTION: Professional installation instructions: This product is designed for specific applications and needs to be

installed by qualified personnel with RF and regulatory related knowledge. The general user shall not attempt to install

or change the setting.

16 VEP4600 installation