Install Guide

Figure 9. Platfrom rail attachment
2. Repeat on the other side of the platform.
3. Attach the outer platform rails to the two-post rack rails using two user-supplied screws on each side.
4. After you install both rails, line up the platform rails with the installed rack rails. Slide the platform in until it is flush with the middle of
rack.
About three inches before you fully insert your platform, the rail locking feature engages to keep the platform from inadvertently sliding
out and falling.
Figure 10. Platform mid-mounted on two posts
NOTE: Do not the use the mounted rails as a shelf or a workplace.
To remove the platform, unscrew the rack-mounting screws and slide the platform forward.
Alternative mounting positions
How to reverse the rail mounting brackets.
If the users want to front-mount (flush-mount) the unit, remove and re-position the L-brackets with the following steps:
1. Remove 8x M3 screws on each rail assembly with number 1 Phillips screw driver.
VEP4600 installation
19