Install Guide

7. Tighten the screws with a number 1 Philips screwdriver on the terminal block to secure the number 10 to number 3 AWG wires.

Figure 23. Tighten wires to terminal block

8. Mate the terminal block to the connector on DC PSU. Place the VEP4600 System Label from the kit on top of the DC PSU cover.

Figure 24. Mate terminal block to DC PSU

9. Locate the overlay label in the kit and place it over the existing label in the unit.

Figure 25. DC overlay label

10. Insert DC PSUs to switch.

Power supplies