Setup Guide

Rack mounting
When you prepare your equipment rack, ensure that the rack is grounded. Ground the equipment rack to the same ground point the
power service in your area uses. The ground path must be permanent.
System ground
Dell recommends grounding your system. Use VEP4600 in a CBN.
Fans and airflow
Fan installation is done as part of the factory install based on stock keeping unit (SKU) type. VEP 4600 supports an AC normal fan unit
with fan airflow from the I/O to the PSU.
For proper ventilation, position the platform in an equipment rack or cabinet with a minimum of 5 inches (12.7 cm) of clearance around the
exhaust vents. The fan speed varies based on internal temperature monitoring. The platform never intentionally turns off the fans.
Power
Connect the platform to the applicable power source using the appropriate power cable. An AC power cable is included with the platform.
When installing AC platforms, follow the requirements of the National Electrical Code ANSI/NFPA 70, where applicable.
The platform is powered-up when the power cable is connected between the platform and the power source.
CAUTION:
Always disconnect the power cable before you service the power supply slots. The platform has multiple
power cords. Before servicing, ensure that all power cords are disconnected.
CAUTION: Use the power supply cable as the main disconnect device. Ensure that the socket-outlet is located/installed
near the equipment and is easily accessible.
Storing components
If you do not install the VEP4600 and components immediately, properly store the platform and all optional components following these
guidelines:
• Storage location temperature must remain constant. The storage range is from -40°C to 70°C (-40°F to 158°F).
• Store on a dry surface or floor, away from direct sunlight, heat, and air conditioning ducts.
• Store in a dust-free environment.
NOTE:
ESD damage can occur when components are mishandled. Always wear an ESD-preventive wrist or heel ground
strap when handling the platform and its accessories. After you remove the original packaging, place the VEP4600 and
its components on an anti-static surface.
6 Site preparations