Users Guide
Parameter # Parameter data
0 = TCP
1 = UDP
2 = both TCP and UDP
Data 2:5—port number
[2:3]—Port number from the ports blocked
or unblocked based on the state.
[4:5]—Port number till the ports are blocked
or u nblocked based on the state.
Remove the IPv6 port number rule 35 Data 1—Protocol TCP and UDP
0 = TCP
1 = UDP
2 = both TCP and UDP
Data 2:3—port number
[2:3]—Port number from the ports blocked
or unblocked based on the state.
Remove the IPv6 port number range rule 36 Data 1—Protocol TCP and UDP
0 = TCP
1 = UDP
2 = both TCP and UDP
Data 2:5—port number
[2:3]—Port number from the ports blocked
or unblocked based on the state.
[4:5]—Port number till the ports are blocked
or u nblocked based on the state.
Event log
To get the IPMI event log, use the ipmitool sel list command.
To clear the event log, use the ipmitool sel clear command.
For IPMI event log settings, see the IPMI Specication v2.0 chapter 31.4 Reserve SEL Command and 31.5 Get SEL Entry Command.
Reserve SEL command
Use reserve system event log (SEL) to set the present owner of the SEL. This reservation provides a limited amount of protection on
repository access from the IPMB when you delete or incrementally read records. Use get SEL to read the SEL repository.
• Response data byte 1—Completion code
– 81h—cannot execute the command, SEL erase in progress
72
Conguration methods