Users Guide
NOTE: After successfully updating the rmware, power-o and power-on the unit. Make sure all the versions are
current and correct.
updatetool -D CPLD --index=1 -U -e <AZUL_CPLD_Vxx.vme>
root@dellemc-diag-os:~# updatetool -D CPLD --index=1 -U -e <AZUL_CPLD_Vxx.vme>
00
Disable device protect
Disable CPLD protect operation success, wait HW reset
Write image to CPLD
INFO: Yafu INI Configuration File not found... Default options will not be applied...
Creating IPMI session via USB...Done
-------------------------------------------------
YAFUFlash - Firmware Upgrade Utility (Version 5.0.0)
-------------------------------------------------
(C)Copyright 2016, American Megatrends Inc.
Beginning CPLD Update...
Uploading Image : 100%... done
Flashing Firmware Image : 100%... done
Verifying Firmware Image : 100%... done
write CPLD image success
Enable device protect
Update CPLD image success
root@dellemc-diag-os:~# shutdown -h now
[xxx.xxxxxx] reboot: Power down
BIOS Boot Selector for VEP4600
Primary BIOS Version x.xx.x.x-xx
CPLD Version:x.x
CPLD Reset Source=0x44
root@dellemc-diag-os:~# updatetool --dev=ALL --device_version
BIOS version:
x.xx.x.x-xx
CPLD version:
CPLD_VERSION : offset 0x600 = 0x9
7: 4 MAJOR_VER = x
3: 0 MINOR_VER = x
MAIN-BMC version:
x.xx
BACKUP-BMC version:
x.xx
When the update is complete, you must either unplug and replug power cables, or power down and back up using remote power cycle
of system via IPMI, to update the version.
Remote rmware update
Update your BMC, BIOS, and CPLD rmware with the following commands.
NOTE
: DIAG OS version 6 is the minimum conguration to install VEP4600 Expansion Cards.
Boot into BIOS settings
1 Press the delete button after the POST Lower DRAM Memory test appears on the screen.
82
Firmware upgrades