Service Manual
Table Of Contents
- OptiPlex 3280 All-in-One Service Manual
- Safety instructions
- Removing and installing components
- Recommended tools
- Screw list
- Stand
- Cable cover—optional
- Back cover
- Hard drive
- Memory modules
- System-board shield
- Solid-state drive
- System fan
- Coin-cell battery
- Wireless card
- Camera assembly
- Bottom cover
- Heat sink
- Processor
- Rear-I/O bracket
- System board
- Speakers
- Power-button board
- Microphones
- Side I/O-board
- Audio board
- Antenna modules
- Display panel
- Middle frame
- Software
- System setup
- Troubleshooting
- Getting help and contacting Dell
About this task
The following image indicates the location of the system-board shield and provides a visual representation of the removal procedure.
Steps
1. Remove the five screws (M3x5) that secure the system-board shield to the display-assembly base.
2. Lift the system-board shield off the display-assembly base.
Installing the system-board shield
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the system-board shield and provides a visual representation of the installation procedure.
28
Removing and installing components