Administrator Guide

Product Information Guide 9
• Plug the computer into a different outlet so that the computer and the receiver are on
different branch circuits.
If necessary, consult an authorized Technical Support representative or an experienced
radio/television or EMC technician for additional suggestions.
Information Technology Equipment (ITE), including peripherals, expansion cards, printers,
input/output (I/O) devices, monitors, and so on, that are integrated into or connected to the
system should match the electromagnetic environment classification of the computer system.
A Notice About Shielded Signal Cables: Use only shielded cables for connecting peripherals to any
device to reduce the possibility of interference with radio communications services. Using shielded
cables ensures that you maintain the appropriate EMC classification for the intended environment.
It has been determined that this product is a Class A harmonized product. The following sections
provide country-specific EMC/EMI or product safety information.
FCC Notice (U.S. Only)
Class A
This product has been tested and found to comply with the limits for a Class A digital device
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment.
This product generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the manufacturer's instruction manual, may cause harmful interference with radio
communications. Operation of this product in a residential area is likely to cause harmful
interference, in which case you will be required to correct the interference at your own expense. This
device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
• This device may not cause harmful interference.
• This device must accept any interference received, including interference that may cause
undesired operation.
Notice: The FCC regulations provide that changes or modifications not expressly approved
by Dell Inc. could void your authority to operate this equipment.
These limits are designed to provide reasonable protection against harmful interference in
a non-residential installation. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful interference with radio or
television reception, which can be determined by turning the equipment off and on, you are
encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the antenna of the radio/television receiver.
• Increase the separation between this equipment and the radio/television receiver.
• Plug the equipment into a different outlet so that the equipment and the radio/television
receiver are on different power mains branch circuits.
• Consult an authorized service technician or an experienced radio/television technician for
additional suggestions.
RGD3KA04.book Page 9 Monday, November 10, 2014 12:25 PM