Users Guide

To install, enable, and configure this feature, use the following command:
./Enable-iDRACAccessHostRoute <Enable-Flag> [ <source-port> <source-IP-range/source-ip-
range-mask>]
<Enable-Flag>=0
Disable
<source-port> and <source-IP-range/source-ip-range-mask> are not required.
<Enable-Flag>=1
Enable
<source-port> is required and <source-ip-range-mask> is optional.
<source-IP-range>
IP range in <IP-Address/subnet-mask> format. Example: 10.95.146.98/24
Coexistence of OpenManage Server Administrator and iDRAC Service
Module
In a system, both OpenManage Server Administrator and the iDRAC Service Module can co-exist and continue to function
correctly and independently.
If you have enabled the monitoring features during the iDRAC Service Module installation, then after the installation is complete
if the iDRAC Service Module detects the presence of OpenManage Server Administrator, it disables the set of monitoring
features that overlap. If OpenManage Server Administrator is running, the iDRAC Service Module disables the overlapping
monitoring features after logging to the OS and iDRAC.
When you re-enable these monitoring features through the iDRAC interfaces later, the same checks are performed and the
features are enabled depending on whether OpenManage Server Administrator is running or not.
Using iDRAC Service Module from iDRAC web
interface
To use the iDRAC Service Module from the iDRAC web interface:
1. Go to IDRAC Settings > Overview > iDRAC Service Module > Configure Service Module.
The iDRAC Service Module Setup page is displayed.
2. You can view the following:
● Installed iDRAC Service Module version on the host operating system
● Connection status of the iDRAC Service Module with iDRAC.
NOTE:
When a server has multiple operating systems and iDRAC Service Module is installed in all operating systems,
then iDRAC connects only with the most recent instance of iSM among all operating systems. An error is displayed for all
the older instances of iSM on other operating systems. To connect iSM with iDRAC on any other operating system
which already has iSM installed, uninstall and reinstall iSM on that particular operating system.
3. To perform out-of-band monitoring functions, select one or more of the following options:
● OS Information—View the operating system information.
● Replicate Lifecycle Log in OS Log—Include Lifecycle Controller logs to operating system logs. This option is disabled
if OpenManage Server Administrator is installed on the system.
● WMI Information— Include WMI information.
● Auto System Recovery Action—Perform auto recovery operations on the system after a specified time (in seconds):
○ Reboot
○ Power Off System
○ Power Cycle System
This option is disabled if OpenManage Server Administrator is installed on the system.
292
Using iDRAC Service Module