Owner's Manual

Using Dell Online Diagnostics 21
Tests Selected
Use this tab to run the tests you selected in the Select Test(s) to Run pane.
This tab contains the following sections:
• Diagnostic Tests Selected: This list box displays all the tests selected in
the
Select Test(s) to Run pane.
•
Diagnostic Options: Use this section of the Tests Selected tab to run the
selected tests. This section contains the following controls:
NOTE: Double-click the row of a particular test in the Status tab, to view
detailed information.
Status
Use this tab to view the status of the tests that are currently running or have
completed execution. Elapsed Time and Overall Progress appear as part of
Status. Elapsed Time is shown in the format of hh:mm:ss and is the amount
of time that elapsed, since the job group of tests started to run. Overall
Progress is the cumulative progress of all the tests in the current job group.
The status of each test is displayed under the following column headings:
• ID : Auto-generated test ID.
•
Device: The device on which the test is running.
•
Test: The test being executing.
•
Progress: Test progress indicated in percentage.
•
Cur. Pass: Indicates the current pass that is running if you selected the
Number of Passes option for the test.
Run Tests Starts the selected tests. You can run multiple tests at the
same time.
Quick Test Uses a faster algorithm to conduct a specific test. If no
errors are reported after running in Quick Test mode and
you still suspect that the tested hardware has problems,
it is recommended that you clear (deselect) Quick Test
mode and run the same test again.
Number of Passes Specifies the number of iterations for the selected test.
The minimum value is 1 and the maximum is 20.