Administrator Guide

Virtual Server Networking CLI | 117
Usage
Information
Entering the disable command in hypervisor configuration mode disables VSN in the
current hypervisor session. It does not remove connectivity with the hypervisor or
remove the session information from the system configuration.
Enter
no disable to re-enable a configured hypervisor session.
hypervisor
S5000
MXL
Specify the name of a hypervisor session with which VSN will connect.
Syntax
[no] hypervisor name
Parameters
Defaults
None
Command Modes
CONFIGURATION
Command
History
Usage
Information
After you enter the command, you are placed in hypervisor configuration mode to
configure settings for the session.
Enter the
no hypervisor name command to remove the configuration of a specified
hypervisor session from the running configuration and close active hypervisor
sessions without removing the VSN agent from the system.
mode
S5000
MXL
Set the hypervisor mode used to retrieve configuration information on virtual servers.
Syntax
[no] mode {check | config}
Defaults
config
name Enter up to 40 characters to specify the name of a hypervisor session
to which you want to connect on network servers.
Version 9.6(0.0) Introduced on the S5000.
Version 9.2(0.0) Introduced on the MXL switch.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.8.0 Introduced on the S4810.