Administrator Guide

118 | Virtual Server Networking CLI
www.dell.com | support.dell.com
Parameters
Command Modes
HYPERVISOR
Command
History
Usage
Information
You can use the mode command to change the way in which virtual-server
information is retrieved in an existing hypervisor session.
The following log messages are displayed when the hypervisor mode
check is used to
retrieve configuration information on virtual servers:
Message 1
Dec 1 04:57:48: %STKUNIT0-M:CP %VSNMGR-5-VSN_VLAN_DISCOVERY: Te 0/35, Vlan:
4001-4008,4011-4012
Message 2
Dec 1 04:56:46: %STKUNIT0-M:CP %VSNMGR-5-VSN_VLAN_WITHDRAWAL: Te 0/35, Vlan:
4001-4008,4011-4012
package install
S5000
MXL
Install an Open Automation package, such as Virtual Server Networking. This
command downloads the package from the specified location, and installs it in the
internal flash memory on a switch.
Syntax
package install location
Parameters
check VSN retrieves configuration information about virtual servers from a
hypervisor and notifies the system administrator if the configuration
has changed (for example, a VLAN has been added or removed).
Changes in Dell Networking OS configuration parameters must be
entered manually on the switch.
config VSN retrieves configuration information from the Hypervisor and
implements any necessary configuration changes automatically.
Version 9.6(0.0) Introduced on the S5000.
Version 9.2(0.0) Introduced on the MXL switch.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.8.0 Introduced on the S4810.
location Enter the location where you want to install an Open Automation
package, where location is one of the following values:
• flash://filename installs the VSN package file stored in flash
memory on the switch.
• ftp://userid:password@host-ip-address/file-path logs in and
installs VSN from a file stored on an FTP server.
• tftp://host-ip-address/file-path installs VSN from a file stored on
a TFTP server.
• nfsmount://filepath copies from a file stored on an NFS mount
file system.