Administrator Guide

48 | Bare Metal Provisioning (BMP) - CLI
www.dell.com | support.dell.com
Related
Commands
show reload-type — displays the current reload mode (BMP or Normal mode).
stop bmp — stops the BMP process and prevents a loop if the DHCP server is not
found.
script post-config
z

S5000, MXL
Switch
To run the post-configuration script after the pre-configuration script is executed
during the BMP reload, ensure that this command is present in the
startup-configuration.
Syntax
script post-config {script-name}
Parameters
Defaults
None.
Command Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
show boot bmp
z

S5000, MXL
Switch
Displays the current state of the BMP process.
Syntax
show boot bmp
Defaults
None.
Command Modes
EXEC
scriptname Enter the name of the script to be run after the BMP start-up
configuration has been applied.
Version 9.6(0.0) Introduced on the S5000.
Version 9.5(0.1) Introduced on the Z9500.
Version 9.3(0.0) Introduced on the S6000.
Version 9.2(0.0) Introduced on the MXL Switch and S4820T.
Version 9.1.0.0 Introduced on the Z9000 and S4810.