Administrator Guide

92 | Smart Scripting CLI
www.dell.com | support.dell.com
• ftp: Copy from the remote file system (tftp://hostip//filepath)
The downloaded files are stored into a dedicated folder (/usr/pkg/ss-scripts).
script list execute
,
S5000, Z9000,
Z9500, MXL
Switch
Configure a list of scripts to run when the switch is rebooted. The scripts may be run
before or after loading the configuration file.
Syntax
script list execute list-name {on-boot | networkup}
To delete the list of scripts for an event, use the no script list execute command.
Parameters
Defaults
None
Command Modes
CONFIGURATION
Command
History
Usage
Information
The maximum number of lists to configure is two. In Normal Reload mode, the
on-boot list executes before applying configurations; it is not executed in BMP mode.
The network list is executed after applying configurations; it executes in BMP and
Normal Reload mode.
Note: In case of stack, the scripts from the ss-scripts will be synchronized across the stack for
every one hour. When the stack forms first, the script synchronization from the master to
members will happen only after 10 minutes.
list-name Enter the file name that contains the list of scripts to be executed and
the sequence in which the scripts will execute.
on-boot Enter the keywords on-boot to execute the list of scripts before the
configuration file is loaded.
network-up Enter the keywords network-up to execute the list of scripts after
the configuration file is loaded.
Version 9.6(0.0) Introduced on the S5000.
Version 9.5(0.1) Introduced on the Z9500.
Version 9.3(0.0) Introduced on the S6000.
Version 9.2(0.0) Introduced on the S4810, S4820T, Z9000, and MXL Switch.