Service Manual

Parameters
name
Enter up to 40 characters to specify the name of a
hypervisor session to which you want to connect on
network servers.
Defaults none
Command Modes HYPERVISOR
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.6(0.0) Introduced on the S5000.
9.2(0.0) Introduced on the MXL switch.
8.3.19.0 Introduced on the S4820T.
8.3.8.0 Introduced on the S4810.
Usage Information
To configure settings for the session, after you enter the command, you are placed
in Hypervisor Configuration mode.
To remove the configuration of a specified hypervisor session from the running
configuration and close active hypervisor sessions without removing the VSN agent
from the system, enter the no hypervisor name command.
mode
Set the Hypervisor mode used to retrieve configuration information on virtual servers.
S4810, S4820T, S5000, and MXL Switch
Syntax
[no] mode {check | config}
Parameters
check
VSN retrieves configuration information about virtual servers
from a Hypervisor and notifies the system administrator if
the configuration has changed (for example, a VLAN is
added or removed). Manually enter changes in the Dell
Networking OS configuration parameters.
config
VSN retrieves configuration information from the Hypervisor
and implements any necessary configuration changes
automatically.
Defaults config
Command Modes HYPERVISOR
Virtual Server Networking CLI
129