Service Manual

Version Description

9.8(0.0P2) Introduced on the S3048–ON.

9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, S6000–

ON, Z9000, Z9500, IOA, and MXL.

Usage Information

For an initial setup, the config-scr-download parameter of the reload-type

command is enabled. After the configuration file successfully downloads, the

config-scr-download parameter is automatically disabled. You can enable it

again using the

reload-type command.

Commands

• reload-type — allows you to configure the reload-type options in reload-type

sub command mode.

• show reload-type — displays the current Reload mode (BMP mode or Normal

mode).

dhcp-timeout

Allows you to configure the DHCP timeout limit.

S4810, S4820T, S3048–ON, S3100 series, S4048–ON, S5000, S6000,

S6000–ON, Z9100–ON, Z9500, IOA, and MXL

Syntax

dhcp-timeout minutes

To reset the DHCP time out limit, use the no dhcp-timeout minutes

command.

Parameters

dhcp-timeout

minutes

Configure the DHCP timeout (in minutes) after which the

BMP exits. The range is from 0 to 50. If you enter a range of

0, the timeout is 0 (no limit).

NOTE: Dell Networking recommends setting the value

to 2 or higher.

Defaults Disabled

Command Modes RELOAD-TYPE CONFIGURATION

Command History

This guide is platform-specific. For command information about other platforms,

see the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.8(2.0) Introduced on the S3100 series.

Bare Metal Provisioning CLI