Service Manual

Version Description
8.3.19.0 Introduced on the S4820T.
Usage Information
To upgrade any NVRAM changes to the chassis caused by the following CLI
commands, use the reload conditional nvram-cfg-change command on a
switch running BMP.
• stack-unit {unit} stack-group
• stack-unit {unit} port {fanout-portid} portmode quad
• asf-mode
• cam-acl
• buffer-profile
retry-count
Allows you to configure the number of retries for downloading the Dell Networking OS image and
configuration file.
S4810, S4820T, S3048–ON, S3100 series, S4048–ON, S5000, S6000,
S6000–ON, Z9100–ON, Z9500, IOA, and MXL
Syntax
retry-count number
To reset the number of retries, use the no retry-count number
Parameters
retry-count
number
Enter the keyword retry-count, then the number of times
to retry downloading the Dell Networking OS image,
configuration file, or script file from the DHCP / file servers,
if the servers are not reachable. The retry limit is from 0 to 6.
If the retry limit is 0, no retry performs. The default is 0.
Defaults none
Command Modes RELOAD-TYPE CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(1.0P1) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048–ON.
9.8(0.0P2) Introduced on the S3048–ON.
Bare Metal Provisioning CLI
47