Setup Guide
bmp logging
Congures the syslog messages in a console while BMP is running.
S4810, S4820T, S3048–ON, S3100 series, S4048–ON,
S4048T–ON, S5000, S5048F-ON, S6000, S6000–ON,
S6010–ON, S6100–ON, Z9100–ON, Z9500,
C9010, , IOA, FN-
IOM, and MXL
Syntax
bmp logging {enable | disable}
Parameters
enable
Enables the syslog messages in the console while BMP is running.
disable
Disables the syslog messages in the console while BMP is running.
Defaults none
Command Modes EXEC
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
The following is a list of the Dell EMC Networking OS version history for this command.
Version Description
9.10(0.1) Introduced on the S4048T–ON and S6010–ON.
9.10(0.0) Introduced on the S6100–ON.
9.9(0.0) Introduced on the C9010.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0P1) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048–ON.
9.8(0.0P2) Introduced on the S3048–ON.
9.7(0.0) Introduced on the S6000–ON.
9.6(0.0) Introduced on the S6000.
9.5(0.1) Introduced on the Z9500.
9.5(0.0) Introduced on the S4810, S4820T, S6000, Z9000, and MXL.
Usage Information
This command is applicable only when BMP is running and enables or disables the syslog messages (with a
Severity level >2, critical).
When BMP is not running, the following error message displays: % Error: bmp process is not
running.
Bare Metal Provisioning CLI 41