Setup Guide
Version Description
9.2(0.0) Introduced on the MXL Switch.
9.1(0.0) Introduced on the Z9000 and S4810.
8.3.19.0 Introduced on the S4820T.
Usage Information
To upgrade any NVRAM changes to the chassis caused by the following CLI commands, use the reload
conditional nvram-cfg-change command on a switch running BMP.
• stack-unit {unit} stack-group
• stack-unit {unit} port {fanout-portid} portmode quad
• asf-mode
• cam-acl
• buffer-profile
reload-type
Allows you to congure the reload-type options in reload-type sub command mode.
S4810, S4820T, S3048–ON, S3100 Series, S4048–ON,
S4048T–ON, S5000, S5048F-ON, S6000, S6010–ON, S6100–
ON, Z9100–ON, Z9500, C9010, IOA, FN-IOM, and MXL
Syntax
reload-type
Defaults BMP
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
The following is a list of the Dell EMC Networking OS version history for this command.
Version Description
9.10(0.1) Introduced on the S4048T–ON and S6010–ON.
9.10(0.0) Introduced on the S6100–ON.
9.9(0.0) Introduced on the C9010.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0P1) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048–ON.
9.8(0.0P2) Introduced on the S3048–ON.
9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, S6000–ON, Z9000, Z9500, IOA, and
MXL.
9.6(0.0) Introduced on the S5000.
Bare Metal Provisioning CLI 47