Users Guide

hypervisor
Species the name of a hypervisor session with which VSN connects.
S4810, S4820T, S5000, and MXL Switch
Syntax
[no] hypervisor name
Parameters
name
Enter up to 40 characters to specify the name of a hypervisor session to which you want
to connect on network servers.
Defaults none
Command Modes HYPERVISOR
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
The following is a list of the Dell EMC Networking OS version history for this command.
Version Description
9.6(0.0) Introduced on the S5000.
9.2(0.0) Introduced on the MXL switch.
8.3.19.0 Introduced on the S4820T.
8.3.8.0 Introduced on the S4810.
Usage Information
To congure settings for the session, after you enter the command, you are placed in Hypervisor Conguration
mode.
To remove the conguration of a specied hypervisor session from the running conguration and close active
hypervisor sessions without removing the VSN agent from the system, enter the no hypervisor name
command.
mode
Sets the Hypervisor mode you use to retrieve conguration information on virtual servers.
S4810, S4820T, S5000, and MXL Switch
Syntax
[no] mode {check | config}
Parameters
check
VSN retrieves conguration information about virtual servers from a Hypervisor and
noties the system administrator if the conguration has changed (for example, you add
or remove VLAN). Manually enter changes in the Dell EMC Networking OS conguration
parameters.
Virtual Server Networking CLI 127