Users Guide

reload conditional nvram-cfg-change
After saving the BMP conguration, to perform a reload on the chassis due to conguration changes that changes the NVRAM content,
use this command.
S4810, S4820T, S3048–ON, S3100 series, S4048–ON,
S4048T–ON, S5000, S6000, S6000–ON, S6010–ON, S6100–
ON, Z9100–ON, Z9500,
C9010, , IOA, FN-IOM, and MXL
Switch
Syntax
reload {conditional nvram-cfg-change | no-confirm [discard-running]}
Parameters
condtional
nvram-cfg-
change
Reload the chassis only if there are any NVRAM conguration changes.
no-confirm
Reload the chassis after writing the running-config to startup-config without
prompting for further conrmation.
[discard-
running]
Discard writing the running-config to startup-config.
Defaults none
Command Modes EXEC
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
The following is a list of the Dell EMC Networking OS version history for this command.
Version Description
9.10(0.1) Introduced on the S4048T–ON and S6010–ON.
9.10(0.0) Introduced the no-confirm option. Introduced on the S6100–ON.
9.9(0.0) Introduced on the C9010.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0P1) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048–ON.
9.8(0.0P2) Introduced on the S3048–ON.
9.7(0.0) Introduced on the S6000–ON.
9.6(0.0) Introduced on the S5000.
9.5(0.1) Introduced on the Z9500.
9.3(0.0) Introduced on the S6000.
9.2(0.0) Introduced on the MXL Switch.
46 Bare Metal Provisioning CLI