Administrator Guide

Version Description
8.3.8.0 Introduced on the S4810.
Usage
Information
VSN tries to establish a connection with a hypervisor only after you configure the
user credentials (username and password) with the access command.
disable
Stop a hypervisor session.
S4810, S4820T, S5000, and MXL Switch
Syntax
[no] disable
Defaults disable
Command
Modes
HYPERVISOR
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.6(0.0) Introduced on the S5000.
9.2(0.0) Introduced on the MXL switch.
8.3.19.0 Introduced on the S4820T.
8.3.8.0 Introduced on the S4810.
Usage
Information
Entering the disable command in Hypervisor Configuration mode disables VSN in
the current hypervisor session. It does not remove connectivity with the hypervisor
or remove the session information from the system configuration.
To re-enable a configured hypervisor session, use the no disable command.
hypervisor
Specify the name of a hypervisor session with which VSN connects.
S4810, S4820T, S5000, and MXL Switch
Syntax
[no] hypervisor name
Parameters
name
Enter up to 40 characters to specify the name of a hypervisor
session to which you want to connect on network servers.
Virtual Server Networking CLI
113