Administrator Guide

Defaults none
Command
Modes
HYPERVISOR
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.6(0.0) Introduced on the S5000.
9.2(0.0) Introduced on the MXL switch.
8.3.19.0 Introduced on the S4820T.
8.3.8.0 Introduced on the S4810.
Usage
Information
To configure settings for the session, after you enter the command, you are placed
in Hypervisor Configuration mode.
To remove the configuration of a specified hypervisor session from the running
configuration and close active hypervisor sessions without removing the VSN agent
from the system, enter the no hypervisor name command.
mode
Set the Hypervisor mode used to retrieve configuration information on virtual servers.
S4810, S4820T, S5000, and MXL Switch
Syntax
[no] mode {check | config}
Parameters
check
VSN retrieves configuration information about virtual servers
from a Hypervisor and notifies the system administrator if the
configuration has changed (for example, a VLAN is added or
removed). Manually enter changes in the Dell Networking OS
configuration parameters.
config
VSN retrieves configuration information from the Hypervisor
and implements any necessary configuration changes
automatically.
Defaults config
Command
Modes
HYPERVISOR
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
114
Virtual Server Networking CLI