Administrator Guide

When BMP is not running, the following error message displays: % Error: bmp

process is not running.

NOTE: This CLI command is only available in BMP normal context, which is

similar to providing the L option in the Factory-default context.

boot-type

Allow you to configure the reload type.

S4810, S4820T, S5000, S6000, Z9000, Z9500, IOA, and MXL Switch

Syntax

boot-type { bmp-reload | normal-reload }

To reset the boot-type mode, use the no boot-type { bmp-reload |

normal-reload }

command.

Parameters

bmp-reload

Reloads the system in BMP mode. After performing the

reload, the system retrieves the Dell Networking OS image

and startup-configuration files from the flash.

normal-

reload

Reloads the system in manual interactive mode.

Defaults none

Command

Modes

RELOAD-TYPE CONFIGURATION

Command

History

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, Z9000,

Z9500, IOA, and MXL Switch.

Commands

• reload-type — allows you to configure the reload-type options in reload-type

sub command mode.

• show reload-type — displays the current Reload mode (BMP mode or Normal

mode).

Bare Metal Provisioning CLI