Service Manual

Version Description
8.3.19.0 Introduced on the S4820T.
8.3.8.0 Introduced on the S4810.
Usage Information
Entering the disable command in Hypervisor Configuration mode disables VSN in the
current hypervisor session. It does not remove connectivity with the hypervisor or
remove the session information from the system configuration.
To re-enable a configured hypervisor session, use the no disable command.
hypervisor
Specifies the name of a hypervisor session with which VSN connects.
S4810, S4820T, S5000, and MXL Switch
Syntax
[no] hypervisor name
Parameters
name
Enter up to 40 characters to specify the name of a hypervisor
session to which you want to connect on network servers.
Defaults none
Command Modes HYPERVISOR
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.6(0.0) Introduced on the S5000.
9.2(0.0) Introduced on the MXL switch.
8.3.19.0 Introduced on the S4820T.
8.3.8.0 Introduced on the S4810.
Usage Information
To configure settings for the session, after you enter the command, you are placed in
Hypervisor Configuration mode.
Virtual Server Networking CLI 148