Service Manual

To remove the configuration of a specified hypervisor session from the running
configuration and close active hypervisor sessions without removing the VSN agent
from the system, enter the no hypervisor name command.
mode
Sets the Hypervisor mode you use to retrieve configuration information on virtual servers.
S4810, S4820T, S5000, and MXL Switch
Syntax
[no] mode {check | config}
Parameters
check
VSN retrieves configuration information about virtual servers
from a Hypervisor and notifies the system administrator if the
configuration has changed (for example, you add or remove
VLAN). Manually enter changes in the Dell Networking OS
configuration parameters.
config
VSN retrieves configuration information from the Hypervisor and
implements any necessary configuration changes automatically.
Defaults config
Command Modes HYPERVISOR
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.6(0.0) Introduced on the S5000.
9.2(0.0) Introduced on the MXL.
8.3.19.0 Introduced on the S4820T.
8.3.8.0 Introduced on the S4810.
Usage Information
You can use the mode command to change how virtual-server information is retrieved
in an existing Hypervisor session.
Virtual Server Networking CLI 149