Service Manual

Version Description
9.5(0.1) Introduced on the Z9500.
9.5(0.0) Introduced on the S4810, S4820T, S6000, Z9000, and MXL.
Usage Information
This command is applicable only when BMP is running and enables or disables the
syslog messages (with a Severity level >2, critical).
When BMP is not running, the following error message displays: % Error: bmp
process is not running.
NOTE: This CLI command is only available in BMP normal context, which is
similar to providing the L option in the Factory-default context.
boot-type
Allows you to configure the reload type.
S4810, S4820T, S3048–ON, S3100 series,
S4048–ON, S5000, S6000, S6000–ON, S6100–
ON, Z9100–ON, Z9500, C9010, IOA, and MXL
Syntax
boot-type { bmp-reload | normal-reload }
To reset the boot-type mode, use the no boot-type { bmp-reload | normal-
reload } command.
Parameters
bmp-reload
Reloads the system in BMP mode. After performing the reload,
the system retrieves the Dell Networking OS image and startup-
configuration files from the flash.
normal-reload
Reloads the system in manual interactive mode.
Defaults none
Command Modes RELOAD-TYPE CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.0) Introduces on the S6100–ON.
Bare Metal Provisioning CLI 48