Service Manual

Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.0) Introduces on the S6100–ON.
9.9(0.0) Introduced on the C9010.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0P1) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048–ON.
9.8(0.0P2) Introduced on the S3048–ON.
9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, S6000–ON,
Z9000, Z9500, IOA, and MXL.
Usage Information
For an initial setup, the config-scr-download parameter of the reload-type
command is enabled. After the configuration file successfully downloads, the config-
scr-download
parameter is automatically disabled. You can enable it again using the
reload-type command.
Related
Commands
• reload-type — allows you to configure the reload-type options in reload-type sub
command mode.
• show reload-type — displays the current Reload mode (BMP mode or Normal
mode).
dhcp-timeout
Allows you to configure the DHCP timeout limit.
S4810, S4820T, S3048–ON, S3100 series,
S4048–ON, S5000, S6000, S6000–ON, S6100–
ON, Z9100–ON, Z9500, C9010, IOA, and MXL
Syntax
dhcp-timeout minutes
To reset the DHCP time out limit, use the no dhcp-timeout minutes command.
Bare Metal Provisioning CLI 50