Service Manual

Parameters
dhcp-timeout
minutes
Configure the DHCP timeout (in minutes) after which the BMP
exits. The range is from 0 to 50. If you enter a range of 0, the
timeout is 0 (no limit).
NOTE: Dell Networking recommends setting the value to
2 or higher.
Defaults Disabled
Command Modes RELOAD-TYPE CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.0) Introduces on the S6100–ON.
9.9(0.0) Introduced on the C9010.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0P1) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048–ON.
9.8(0.0P2) Introduced on the S3048–ON.
9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, S6000–ON,
Z9000, Z9500, IOA, and MXL.
Related
Commands
• reload-type — allows you to configure the reload-type options in reload-type sub
command mode.
• show reload-type — displays the current Reload mode (BMP mode or Normal
mode).
Bare Metal Provisioning CLI 51