Service Manual

Related
Commands
• reload-type — allows you to configure the reload-type options in reload-type sub
command mode.
• show reload-type — displays the current Reload mode (BMP mode or Normal
mode).
reload conditional nvram-cfg-change
After saving the BMP configuration, to perform a reload on the chassis due to configuration changes that
changes the NVRAM content, use this command.
S4810, S4820T, S3048–ON, S3100 series,
S4048–ON, S5000, S6000, S6000–ON, S6100–
ON, Z9100–ON, Z9500, C9010, and MXL Switch
Syntax
reload {conditional nvram-cfg-change | no-confirm [discard-
running]}
Parameters
condtional
nvram-cfg-
change
Reload the chassis only if there are any NVRAM configuration
changes.
no-confirm
Reload the chassis after writing the running-config to
startup-config without prompting for further confirmation.
[discard-
running]
Discard writing the running-config to startup-config.
Defaults none
Command Modes EXEC
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.0) Introduced the no-confirm option. Introduced on the S6100–
ON.
9.9(0.0) Introduced on the C9010.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0P1) Introduced on the Z9100–ON.
Bare Metal Provisioning CLI 53