Service Manual

Version Description

9.10(0.0) Introduced on the S6100–ON.

9.9(0.0) Introduced on the C9010.

9.8(2.0) Introduced on the S3100 series.

9.8(1.0P1) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048–ON.

9.8(0.0P2) Introduced on the S3048–ON.

9.7(0.0) Introduced on the S6000–ON.

9.6(0.0) Introduced on the S5000.

9.5(0.1) Introduced on the Z9500.

9.3(0.0) Introduced on the S6000. Replaces the stop jumpstart

command.

9.2(0.0) Introduced on the Z9000, S4810, S4820T, and MXL switch.

Replaces the stop jumpstart command.

9.1(0.0) Introduced on the Z9000 and S4810. Replaces the stop

jumpstart command.

Usage Information

If the switch enters a loop while reloading in BMP mode, use the stop bmp command

on a switch running BMP. A loop occurs when the switch is continuously trying to

contact a DHCP server and a DHCP server is not found. The stop bmp command

stops the switch from connecting to the DHCP server. After you use the

stop bmp

command, the next default reload type is a normal reload as indicated in the show

reload-type or show system brief commands.

The stop bmp command behaves differently in different circumstances:

• While the Dell Networking OS image upgrade is in progress, it aborts the BMP

process after the Dell Networking OS image upgrades.

• When applying configurations from the file, it aborts the BMP process after all the

configurations are applied in the system.

• When running the pre-configuration or post-configuration script, it stops the

script and aborts the BMP process immediately.

• When downloading the configuration or script file, it aborts the BMP process after

the download and does not apply the configuration or run the script.

When you enter GLOBAL CONFIGURATION mode during the BMP process, to avoid

configuration conflicts between you and the BMP process, warning / error messages

display.

Commands

reload-type — allows you to configure the reload-type options in reload-type sub

command mode.

Bare Metal Provisioning CLI 63