Owner's Manual

36 | Bare Metal Provisioning (BMP) - Config
www.dell.com | support.dell.com
expect "ftp>"
send "ls\n"
expect "ftp>"
send "bye\n"
expect eof
print_f10do "configure terminal"
print_f10do "interface TenGigabitEthernet 0/22"
print_f10do "no ip address"
print_f10do "shutdown"
print_f10do "end"
puts "Post-Config Script Execution Successfull !!!!!\r\n"
exit 0
BMP Operations on Servers Overview
The following sections describe how to prepare the different servers for BMP
functionality:
• DHCP Server
• File Server Settings
• Domain Name Server Settings
DHCP Server
To configure the DHCP server use the following information.
DHCP Server Settings
Before you can use BMP mode on a switch, first configure a DHCP server.
Configure the DHCP server with the following set of parameters for each client
switch. For more information, refer to the Dell Networking OS Configuration Guide,
Dynamic Host Configuration Protocol chapter. To assign an IP to the system and
other parameters, configure the DHCP server.
Update the following parameters on the appropriate DHCP server:
• Boot File Name — the Dell Networking OS image loaded on the system. Option
67 in the DHCP offer is the boot file name; the filename is BOOTP payload. If
both are specified, option 67 is used. The system supports the TFTP, HTTP,
HTTPS, SFTP, SCP, FTP, FLASH and USBFLASH protocols.
• Configuration File Name — the configurations applied to the system. The
configuration file name is expected to use option 209. A preconfiguration script
can also be given in option 209 to configure the device by itself for a download
configuration file.