Owner's Manual

Bare Metal Provisioning (BMP) - CLI | 45
script post-config
z

MXL Switch
To run the post-configuration script after the pre-configuration script is executed
during the BMP reload, ensure that this command is present in the
startup-configuration.
Syntax
script post-config {script-name}
Parameters
Defaults
None.
Command Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
show boot bmp
z

MXL Switch
Displays the current state of the BMP process.
Syntax
show boot bmp
Defaults
None.
Command Modes
EXEC
Command
History
scriptname Enter the name of the script to be run after the BMP start-up
configuration has been applied.
Version 9.3(0.0) Introduced on the S6000.
Version 9.2(0.0) Introduced on the MXL Switch and S4820T.
Version 9.1.0.0 Introduced on the Z9000 and S4810.
Version 9.3(0.0) Introduced on the S6000.
Version 9.2(0.0) Introduced on the Z9000, S4810, S4820T, and MXL Switch.