Service Manual

dhcp-timeout
Allows you to configure the DHCP timeout limit.
S4810, S4820T, S3048–ON, S5000, S6000, S6000–ON, Z9500, IOA, and MXL
Syntax
dhcp-timeout minutes
To reset the DHCP time out limit, use the no dhcp-timeout minutes
command.
Parameters
dhcp-timeout
minutes
Configure the DHCP timeout (in minutes) after which the
BMP exits. The range is from 0 to 50. If you enter a range of
0, the timeout is 0 (no limit).
NOTE: Dell Networking recommends setting the value
to 2 or higher.
Defaults Disabled
Command Modes RELOAD-TYPE CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P2) Introduced on the S3048–ON.
9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, S6000–
ON, Z9000, Z9500, IOA, and MXL.
Related
Commands
• reload-type
— allows you to configure the reload-type options in reload-type sub
command mode.
• show reload-type — displays the current Reload mode (BMP mode or Normal
mode).
relay
Allows you to configure the addition of option 82 in DHCP client packets.
S4810, S4820T, S3048–ON, S5000, S6000, S6000–ON, Z9500, IOA, and MXL
Syntax
relay { enable | disable | remote-id { hostname | MAC | Word }}
Bare Metal Provisioning CLI
43